行业资讯
水泥撒布车撒布不均匀的原因？
来源：https://www.sddhfjx.com/ 日期：2020-08-17
水泥撒布车撒布不均匀是我们在使用水泥撒布车过程中不可避免问题，为此小编特针对此问题的引起的原因和方法公布如下，以方便购车朋友在遇到此类问题时能及时，解除大家用车中的烦恼。
Uneven distribution of cement spreader is an inevitable problem in the process of using cement spreader. Therefore, the causes and solutions of this problem are published as follows, so as to facilitate car buyers to solve such problems in time and relieve everyone's troubles in using cars.
一、水泥撒布车撒布不均匀的主要原因
1、 Main reasons for uneven distribution of cement spreader
1.检查沥青喷嘴是否松动或者有堵住的现象；
1. Check whether the asphalt nozzle is loose or blocked;
2.沥青喷嘴位置不统一；
2. The position of asphalt nozzle is not uniform;
3.车速过快或者过慢；
3. The speed is too fast or too slow;
4.沥青粘度过大；
4. The viscosity of asphalt is too high;
5.喷洒管离地高度过高或者过低。
5. The height of spraying pipe from the ground is too high or too low.
水泥撒布车洒布不均匀的方法：
Solutions for uneven distribution of cement spreader:
1.清理全部沥青喷嘴检查是否有损坏的喷嘴及时更换；
1. Clean all asphalt nozzles and check whether there are damaged nozzles and replace them in time;
2.把沥青喷嘴全部调整到统一位置；
2. Adjust all asphalt nozzles to the same position;
3.降低车速控制均码洒布；
3. Reduce the speed and control the uniform distribution;
4、使喷洒管离地高度可调，闭环控制。
4. The height of spraying pipe from the ground can be adjusted and closed-loop controlled.
由于喷洒扇面角会受到车速、沥青种类、温度、粘度等因素影响，所以离地高度尽量根据施工经验确定，并以此作为依据进行调整：喷洒管离地高度太大，会减小沥青喷洒冲击力，弱化“冲击一飞溅～匀化”作用；喷洒管离地高度过低，会减小沥青喷洒扇面重叠数，应根据实际情况调节喷洒管高度以提高沥青喷洒效果。
As the angle of spraying fan will be affected by vehicle speed, asphalt type, temperature, viscosity and other factors, the height above the ground shall be determined according to the construction experience as far as possible, and shall be adjusted based on this: if the spraying pipe is too high from the ground, the impact force of asphalt spraying will be reduced, and the effect of "impact splash homogenization" will be weakened; if the height of spraying pipe is too low, the overlapping number of asphalt spraying fans will be reduced The height of spraying pipe should be adjusted according to the actual situation to improve the asphalt spraying effect.
5、改善沥青特性
5. Improving asphalt properties
沥青黏度大，则沥青流动阻力大，喷射成形小，重叠数减小。为了克服这些不足，一般做法是加大喷嘴通径，但这样做势必减小了射流速度，弱化了“冲击一飞溅～匀化”作用，使横向洒布不均匀。为了提高沥青施工工艺性能，应改善沥青特性。
When the asphalt viscosity is high, the asphalt flow resistance is high, the spray forming is small, and the overlap number is reduced. In order to overcome these shortcomings, the general method is to increase the nozzle diameter, but this will certainly reduce the jet velocity, weaken the "impact splash homogenization" effect, and make the transverse distribution uneven. In order to improve the performance of asphalt construction technology, asphalt properties should be improved.
以上是关于水泥撒布车撒布不均匀的原因和方法的详细介绍，由水泥撒布车出租整理提供，希望对大家有所帮助，如您想要了解更多相关资讯欢迎关注我们的网站。
The above is a detailed introduction to the causes and solutions of uneven spreading of cement spreader. I hope it will help you. If you want to know more about it, please pay attention to our website.
公司地址：济南市槐荫区经一路273号群盛华城2号楼1-404
公司名称：山东途畅路桥工程有限公司 
备案号：